User manual

OPERATING THE RIDE TIME AND TOTAL

TIME CHRONOGRAPHS

STARTING STOPPING AND CLEARING THE

CHRONOGRAPH AND MEMORY

ENGLISH

All data acquisition is controlled by the primary Ride Time or Total Time Chronograph. Ride data

such as Average and Maximum values and Memory Information are only tracked if the primary

chronograph is running. At any time, clearing the Ride Time or Total Time chronograph will also

clear ALL data and memory values.

STARTING AND STOPPING THE RIDE TIME CHRONOGRAPH

The operation of the Ride Time Chronograph is totally automatic and is controlled by speed

input. If the unit is receiving a speed input, the Ride Time Chronograph will run, if the speed

stops, the Ride Time Chronograph will stop.

STARTING AND STOPPING THE TOTAL TIME CHRONOGRAPH

From an initial reading of zero, the Total Time Chronograph starts automatically as soon as it

sees a speed input or is manually started using a QUICK PRESS of the START/STOP key. Once it

has started, the Total Time Chronograph will continue to run until it is stopped using the

START/STOP key.

CLEARING ALL RIDE DATA

To clear the chronograph and all data and memories to zero PRESS & HOLD the START/STOP key

for approximately 2-seconds in the Ride Distance (DST) screen until the chronograph line shows

all zeros.

CYCLE COMPUTER

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 44