User manual

PROGRAM ODOMETERS

ENGLISH

STEP BY STEP—SET CHRONOGRAPH FUNCTION

1. Upon entering the SET Chronograph function display, RT (Ride Time)

or TT (Total Time) will flash in the upper right hand corner of the

display.

2. QUICK PRESS the OPTION key to cycle between RT and TT (Total Time)

settings.

3. Select your choice using a QUICK PRESS of the MODE key and exit the

setting sequence.

RIDE TIME (RT)—When RT is selected the Delphi’s Chronograph will start and

stop with the motion of the wheel. This setting tracks the actual time you are

riding your bike.

TOTAL TIME (TT)—When TT is selected the Delphi’s Chronograph will initially

start with the first rotation of the wheel. However, it will continue to run from

that point, until the timing is stopped, using a QUICK PRESS of the

START/STOP key.

PROGRAM WHEEL SIZE, UNITS

AND CHRONOGRAPH

ENGLISH

STEP 2

STEP 3

Blackburn Delphi Computers are equipped with Separate Odometers for Bike 1 and Bike 2 and

a Combined Odometer showing the total for both bikes. Bike 1 and Bike 2 Odometers may be

reprogrammed with an existing mileage following a battery change.

NOTE: If Odometer 1 and Odometer 2 are set for different units (Miles or Kilometers) as defined

by the Speed and Distance Units settings for Bike 1 and Bike 2, the Combined Odometer

(ODO 1/2) will display in the units set for Bike 1.

NOTE: Make sure you write down your mileage for each Odometer prior to removing the battery if

you wish to reprogram the odometers.

NOTE: If the total capacity of any odometer is exceeded, the lower display line will display

5-dashes.

NOTE: Before you can program any computer settings, the primary chronograph must be cleared

to zero using a 2-second PRESS & HOLD of the S/S key while in the Ride Distance (DST)

screen.

CYCLE COMPUTER

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 38