User manual

STEP BY STEP—ENTER A PRE-PROGRAMMED WHEEL SIZE

1. Choose Bike 1 or Bike 2. (Page 27)

2. Starting in the Distance (DST) screen of the Lower Display Window.

3. PRESS & HOLD the MODE key for approximately 2-seconds.

4. QUICK PRESS the OPTION or START/STOP keys to scroll through the 11 pre-programmed

wheel sizes. "WHEEL" will be shown in the lower line of the display with the

pre-programmed wheel size shown in the center line of the display.

5. Select your choice using a QUICK PRESS of the MODE key and advance to the SET Speed

and Distance units display (Page 34).

STEP 5

PROGRAM WHEEL SIZE, UNITS

AND CHRONOGRAPH

PROGRAM WHEEL SIZE, UNITS

AND CHRONOGRAPH

ENGLISH

STEP 2 & 3

STEP 4

STEP BY STEP—ENTER AN EXACT WHEEL SIZE

1. Choose Bike 1 or Bike 2. (Page 27)

2. Starting in the Distance (DST) screen of the Lower Display Window.

3. PRESS & HOLD the MODE key for approximately 2-seconds.

4. QUICK PRESS the OPTION or START/STOP keys until the display shows 2096 flashing in

the center line of the display.

5. QUICK PRESS the MODE key once. The ones digit will begin to flash.

6. Adjust the digit using QUICK PRESSES of the OPTION and START/STOP keys and enter

your choice into memory using a QUICK PRESS of the MODE key.

7. Repeat until all four digits are entered.

8. A final QUICK PRESS of the MODE key will exit the Wheel Size setting sequence and

advance to the SET Speed and Distance units Display (Page 34).

NOTE: Before you can program any computer settings, the primary chronograph must be cleared

to zero using a 2-second

PRESS & HOLD of the S/S key while in the Ride Distance (DST)

screen.

CYCLE COMPUTER

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 34