User manual

BASIC OPERATION BASIC OPERATION
ENGLISH
ENGLISH
UPPER DATA WINDOW FLOW SEQUENCES
This diagram shows the information which is displayed in the Upper Data Window. You may
choose to show Blank or Cadence in this line.
25
STEP BY STEP—CHANGING THE UPPER DATA WINDOW
INFORMATION
1. By Default the Upper Data Window is Blank (no display data) when you install a new
battery. Any time a Delphi unit is attached to a cadence bracket, CADENCE can be
displayed in the Upper Data Window.
2. To change the Upper Data Window PRESS & HOLD the Upper Display/EL key for
approximately 2-seconds until the value changes.
NOTE: When Cadence is displayed in the Upper Data Window, it is not displayed in the Cadence
sequences of the Lower Data Window.
NOTE: On the Delphi 2.0 cadence will only be displayed if the unit is attached to an accessory
cadence bracket.
26
CYCLE COMPUTER
BLANK W/
BLANK W/
SPEED
SPEED
COMPARISON
COMPARISON
CADENCE W/
CADENCE W/
SPEED
SPEED
COMPARISON
COMPARISON
EL KEY
Blackburn_2/3_Manual 8/3/05 10:00 AM Page 28