User manual

23
BlackVue Software
Configuring Your BlackVue Set-up
1.
Insert the micro SD card into the PC. ( See page 16)
2.
Click the button. The Set-up screen is displayed.
N
If the SD card (where the BlackVue firmware is installed) is not connected to the
PC, you cannot configure the settings as intended.
3.
Configure your BlackVue Set-up.
4.
Click the [Save & Close] button.
N
If the settings are not saved on the Micro SD card, your configuration of the
BlackVue Set-up will not be performed.
N
To reset the settings to their default values, click the [Reset] button.
5.
Remove the micro SD card of your configuration from the PC and insert it
into your BlackVue product.
They are applied to the BlackVue automatically.