Setup guide

13H.264 Network IP Camera User Manual
SECTION 3: EQUIPMENT TESTING AND SYSTEM SETUP
SOURCE
Move up in menu
Move down in menu
Move right in menu
or volume up
Move left in menu
or volume down
MENU (open/close)
Power
Audio output
Monitor control panel
8. Press the SOURCE button on the monitor control panel to open the video source menu. Use the p
and q buttons on the control panel to highlight PC, and then press the MENU button to select that
interface. An indication will appear on the screen conrming your selection.
9. Power off the monitor using the Power button on the control panel.
3.9.2 Starting the NVR/hDVR system software
WARNING
!
Make sure the power sources have an adequate earth grounded. This helps prevent
personal injury or damage to the equipment.
1. Before connecting the power, ensure that the power source conguration switch on the
back of the computer is set to 110VAC.
2. Make sure all cables are securely attached.