Service manual

SKYJACK, Page 21SJIII Series
Section 5 - Procedures Service and Maintenance
8. The display will show “Help: Press Enter”.
By using Left/Right buttons, select the “Access Level ( ? )” from the menu and press the ENTER button.
Contact Skyjack Service Department at:
(44) 1691-676 236 for your Access Level Code Number.
9. The display will show “Access Level Code (xxxx)”.
By using the Up/Down buttons, enter the Access Level Code (xxxx) followed by pressing the ENTER
button.
10. The display will show “Access Level 2”.
By using Left/Right buttons, select the “Setups” from the menu and press the ENTER button.
11. The display will show “Machine Defaults”.
Select the “Machine Defaults” from the menu and press the ENTER button.
12. The display will show “Defaults, 0 = Custom”.
By using Left/Right buttons, select the “X = Group Code” from the menu and press the ENTER button.
13. The display will show “X=GROUP CODE”. (Refer to 5.3-8 for group code)
By using the Up/Down buttons, enter the “Group Code (?)” then by using Left/Right buttons, select the “Curve”
from the menu.
14. The display will show “X=CURVE”. (Refer to 5.3-8 for curve code)
By using the Up/Down buttons, enter the “Curve Code (?)” followed by pressing the ESCAPE button.
15. The display will show “Machine Defaults”.
By using Left/Right buttons, select the “Tilt Setups” from the menu and press the ENTER button.
16. The display will show “Tilt Setups: Calibrate Level”.
Select the “Tilt Setups: Calibrate Level” from the menu and press the ENTER button.
17. The display will show “Calibrate Level: Yes: Enter, No: ESC”.
Select the “Yes” from the menu by press the ENTER button.
18. The display will show “Calibrate Level: Tilt 0.0’ , 0.0’”.
Select the “ESCAPE” from the menu once.
19. The display will show “Tilt Setups Calibrate Level”.
Select the “ESCAPE” from the menu once again.
20. The display will show “Setups Tilt Setups”.
By using Left/Right buttons, select the “Load Setups” from the menu and press the ENTER button.
21. The display will show “Load Setups: Calibrate Load”.
Select the “Load Setups: Calibrate Load” from the menu and press the ENTER button.
22. At this point, elevate the aerial platform at full height, check the harness and making sure it is not stretched
tight, then lower down the platform.
23. The display will show “Calibrate Load: Platform Down?”.
Asking for confirmation that the platform is fully lowered?
Check that the platform is fully lowered then press the ENTER button to confirm.