Service manual

SKYJACK, Page 19SJIII Series

Section 5 - Procedures Service and Maintenance

Lower Loaded

This message is displayed while the platform is being lowered to the next measurement height, when -

an EMPTY platform is being calibrated.

Lowering

This message is displayed while the platform is being lowered, during HEIGHT-only calibration. -

Measuring #

This message is displayed when the platform is stopped during calibration, when the GP102 takes a -

measurement. There will be a short delay while the machine is allowed to stabilize after movement is

stopped.

Must Go Down!

This message occurs if the wrong switch is closed when the GP102 is waiting for the platform to be -

lowered.

Must Go Up!

This message occurs if the wrong switch is closed when the GP102 is waiting for the platform to be -

raised.

Platform Down?

This message is prompting for confirmation that the platform is fully lowered. If necessary the DOWN -

switch can be activated to lower the platform. Press ENTER to confirm when the platform is fully

lowered.

Platform Empty?

This message is prompting for confirmation that the platform is completely empty.Press ENTER to -

confirm if the platform is empty.

Platform Loaded?

This message is prompting for confirmation that the platform is loaded to rated load Press ENTER to -

confirm if the platform is loaded.

Please Lift

This message is prompting for the platform to be raised. The UP switch should be closed. -

Please Lower

This message is prompting for the platform to be lowered. The DOWN switch should be closed. -

Please Wait

This message indicates that the GP102 is busy; the delay will be short (no more than 5s). -

Total Data:

This message is displayed at the end of each phase, to confirm the number of measurements recorded -

by the GP102.