User manual
20
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
4. In the Login window, enter the ID and PW (password) for your encoder, then click Login. The default administrator ID and
PW are root and pass. After entering the ID and PW, the IP Setup window closes.
5. In the IPAdmin Tool window, click Refresh and verify that the entry representing the encoder R0,B0,M0 rack address now
shows the new IP address.
6. Repeat the steps above to setup the IP addresses of the remaining three IP channels of your encoder.
2.7 Setup the encoder Basic Conguration
In this procedure, use Microsoft Internet Explorer (IE) browser to setup the encoder administrator and user passwords, date, and
time. Repeat this subsection for each encoder IP channel.
1. Open the IE browser.
2. In the URL eld (Internet address), enter the IP address for your encoder in the format:
http://<IP address>/
where <IP address> is the IP address of your encoder. Following the example earlier in this guide, the entry would be:
http://192.168.5.20
3. If prompted to install an ActiveX control such as AxAll.cab (publisher Cap Co), follow screen prompts to install the software.
IE prompt to install ActiveX control
NOTE
To load these ActiveX controls, you may need to adjust the security settings of your browser to accept add-ins from
unknown publishers.
4. Before viewing video from the encoder, a logon prompt may appear. Enter the appropriate ID and PW (password). The
default administrator values are:
ID: root
PW: pass