User manual

19H.264 Network Video Encoder
SECTION 2: INSTALLATION AND SETUP
Rack Info Vin Channel
Initial IP Address
(no DHCP)
MAC Address
R0, B0, M0 Vin1 192.168.0.100: 00:13:23:D4:D1:45
R0, B0, M1 Vin2 192.168.0.100 00:13:23:D4:D1:46
R0, B0, M2 Vin3 192.168.0.100 00:13:23:D4:D1:47
R0, B0, M3 Vin4 192.168.0.100 00:13:23:D4:D1:48
If an encoder channel was not found, click the Refresh button every minute until the four channels for your encoder appear
in the list.
2. Right click on the entry for the R0,B0,M0 channel (Vin1) of your encoder, then select IP Address.
IP Setup window
3. In the IP Setup window:
a. Select the Static option if it is not selected. This option is required if video from the encoder will be recorded by a
network DVR, or if you want to view video from the encoder across a WAN (Internet).
b. Enter the IP address for R0,B0,M0 from the encoder IP address eld in Table 2 to the IP Address eld in the IP Setup
window.
c. Enter the subnet mask and gateway for your computer from Table 2 into the Subnet Mask and Gateway elds.
d. Click SETUP, then click OK to conrm the change to network settings. A Login window will open.