User manual
14
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
Static Option
4. In the IP Setup window, click the Static option bullet to select this option.
If you have other compatible network settings you want to apply to the device, enter them in the appropriate locations. Click
Setup to save settings, then click OK to conrm the change to network settings.
5. In the Login window, enter the ID and PW (password) for your encoder and click Login. The default administrator values for
the ID and PW are root and pass. After entering ID and PW, the IP Setup window closes.
6. In the IPAdmin Tool window, click Refresh and verify that the entry representing the encoder now shows the new IP
address.
7. Repeat these steps to establish a xed IP address for each encoder channel.
8. Continue with procedure 2.7 Setup encoder Basic Conguration.