User manual
6
www.sc-black.com
SECTION 2: INSTALLATION AND SETUP
encoder to the LAN for network settings to ensure that your encoder won’t initially conict with other
devices. Your network administrator should also setup WAN (Internet) access to the encoder.
If you encounter a problem and need to contact Supercircuits Support, rst complete the chart in step 1
about your Computer (PC) and encoder network settings, if possible. Support will need this information to
provide assistance.
1. At a PC attached to the same LAN that will be shared with your encoder, determine the IP address,
subnet mask, and default gateway of your PC and record it in Table 1. To nd this information, do
the following at the Windows desktop:
a. Hold down the Windows key and press r (without the quotes) to open the Run dialog box.
b. Type cmd in the entry eld and click OK to open the DOS command window.
c. At the command prompt, enter ipcong. The PC will display Ethernet data associated with
your Ethernet adapter LAN connection.
Example: Typical use of ipcong in Windows XP
d. Enter the IP Address, Subnet Mask, and Default Gateway for your PC’s Ethernet adapter into
Table 2.