User guide

13BlackHawk for MAC Software User Guide
SECTION 3: REMOTE CONFIGURATION SETUP
3.5.3 Device
• ALARM OUT: Set the Sensor In, Motion, and Video Loss for triggering alarm relay HDD Error and Video Loss can trigger
beeping.
• CONTROLLER: Set the controller baud rate and ID.
• PTZ: Set the PTZ baud rate, protocol, and RS-485 network ID.
• MOTION: Setup the motion detection area and the sensitivity.
— SITE: Select the channel
— MOTION ZONE: FULL Zone or PARTIAL Zone
— MOTION SENSITIVITY: 1~9 (High sensitivity level)
• KEY TONE: Sets the Key Tone On or O.
• REMOTE CONTROLLER ID: Sets an ID number on the supplied remote control for its identication.
• SENSOR TYPE: Select the type of each sensor.