Instructions / Assembly

Page 6Rev. 031020

1-888-651-3431

Optional Extension - Parts

Part Description Quantity

A Center Beam 1

B Connector Plate 2

C Leg 2

D Angle Foot 1

E Wheel Rod 8

F Wheel 8

Part Description Quantity

G M10-1.5x130 Hex Cap Bolt 2

H M10-1.5x25 Hex Cap Bolt 2

I M10-1.5x16 Socket Head Bolt 16

J M10 Washer 20

K M10 Nut 4

L Cotter Pin 16

G H I J K L

(1a)

Assembly

Step 1: If the PWC dock is already assembled, disconnect and separate the two beams by remov-

ing the bolts from one side of the connector plates. (If assembling at the same time as the rest of the

dock, install the wheels last to keep the dock lighter and easier to maneuver.) Install the center beam

(A) between the front and rear beams using the connector plates (B) and socket head bolts (I). Only

tighten loosely until all bolts are in place. Then, tighten with an M8 Allen wrench. Do not over-tighten.

(1b) (1c)