Instructions / Assembly

Page 5Rev. 031020

1-888-651-3431

Step 6: Attach the wheels to the main body

using the roller rods (F), wheels (I), and

cotter pins (S). Fit the end of the roller rod

with the smaller indent into a top larger

hole, then slide it through the beam into the

opposite bottom smaller hole. Fit the wheel

in place, then secure each end with a cotter

pin, bending the pin with a needle-nose

pliers to secure.

Step 7: Attach the remaining two wheels (I) and roller (J) to the end of the rear beam using the roller

rod (F) and cotter pins (S). Slide the roller rod into one hole, through the roller t into the space in the

beam, then through the second hole. Fit the wheels onto each end, and secure with cotter pins, bend-

ing with a pliers to secure.

(6a) (6b)

(6c)

(7a) (7b)