Instructions / Assembly

Page 3Rev. 031020
1-888-651-3431
Assembly
Step 1: Connect the front beam (A) and rear beam (B) using the connector plates (G) and socket
head bolts (P). Only tighten loosely until all bolts are in place. Then, tighten with an M8 Allen wrench.
Do not over-tighten.
Step 2: Attach one angle foot (D) to the rear
beam (B) using the rear foot spacer (H),
M10x80 bolts (N), washers (Q), and nuts (R).
Tighten securely with 17mm wrenches.
Step 3: Attach the winch post (C) to the front beam (A) using the M10x130 bolts (M), washers (Q),
and nuts (R). This post may be set to the adjustment that best suits your needs. Tighten securely with
17mm wrenches.
(1a)
(1b) (1c)
(2)
(3)