Owner`s manual

8 9
4. To ignite, push and turn the IGNITION
BURNER knob to MAX.
5. Push and hold ELECTRONIC IGNITION
button until the
IGNITION BURNER lights.
6. If ignition does
NOT occur in 5 seconds, turn
the burner controls
OFF, wait 5 minutes and
repeat the lighting procedure.
7. To ignite remaining burners, turn each
burner knob in sequence to the position,
starting with the burner closest to the
IGNITION BURNER.
8. Once each burner has ignited, turn knobs to
desired setting. If ignitor does not work, follow
match lighting instructions.
Lighting instructions are continued on the
next page.
Safety Tips
1. Before opening LP cylinder valve, check the coupling nut for tightness.
2. When griddle is not in use, turn o all control knobs and LP cylinder valve.
3. Never move griddle while in operation or still hot.
4. Use long-handled barbecue utensils and oven mitts to avoid burns and splatters.
5. Maximum on side shelf is 10 lbs.
6. The grease tray must be inserted into griddle and emptied after each use. Do not remove grease tray until
grill has completely cooled.
7. Clean griddle often, preferably after each cookout. If a bristle brush is used to clean any of the grill cook-
ing surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling.
8. If you notice grease or other hot material dripping from grill onto valve, hose or regulator, turn o gas
supply at once. Determine the cause, correct it, then clean and inspect valve, hose and regulator before
continuing. Perform a leak test.
9. Keep ventilation openings in cylinder enclosure (grill cart) free and clear of debris.
10. The regulator may make a humming or whistling noise during operation. This will not aect safety or use
of grill.
11. If you have a griddle problem see the “Troubleshooting Section”.
12. If the regulator frosts, turn o griddle and LP cylinder valve immediately. This indicates a problem with the
cylinder and it should not be used on any product. Return to supplier!
Ignitor Lighting the Griddle
Do not lean over grill while lighting.
1. In order for the igniter switch to work,
please make sure the battery is properly
installed.
2. Turn OFF gas burner control valves.
3. Turn
ON gas at LP cylinder.
!
!
CAUTION
• Do not use water on a grease re. Personal
injury may result. If a grease re develops,
turn knobs and LP cylinder o.
• Do not leave grill unattended while
preheating or burning o food residue on
HI. If grill has not been regularly cleaned, a
grease re can occur that may damage
the product.