Instruction manual

22
EDGE 540-V3- ITEM CODE: BH91. INSTRUCTION MANUAL
C/A glue.
5) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the verti-
cal stabilizer mounting area. Apply epoxy to
the lower rudder hinge. Set the stabilizer in
place and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a pa-
per towel and rubbing alcohol and hold the sta-
bilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceed-
ing.
 4. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Epoxy glue
Remove
covering
Epoxy glue
Also carefully remove the covering from
the horizontal fin as below the lines which
you drew as same picture below.
 3. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Remove covering.