Instruction manual

14
EDGE 540-V3- ITEM CODE: BH91. INSTRUCTION MANUAL
Cut.
Throttle servo
PARTS REQUIRED
 1) Assemble and mounting the wheel pants
as shown in the following pictures.
INSTALLING THE MAIN LANDING GEAR.
Secure.
INSTALLING THE SPINNER.
Install the spinner backplate, propeller and
spinner cone. The spinner cone is held in
place using two 3mm x 12mm wood screws.
3 x 15mm
1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
INSTALLING THE THROTTLE PUSHROD.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
Throttle pushrod.
Servo arm.
Connector.
Connector.
Secure
Throttle servo