Indoor Fireplace User Manual

TC30.NGO3.C 100308

A porcelain panel set must be used in conjunction with the installation of the burner

assembly. See Installation and Operating Instructions manual for details.

1. Remove three screws from the rear of

the  rebox. Attach the manifold bracket

to the rear of the  rebox with the three

screws previously removed. (Fig. #1)

2. Attach the manifold supply tube to the

bulk head  tting and tighten. (Fig. #2)

Ensure that there are no leaks.

3. Attach the pilot supply tube to the bulk

head  tting and tighten. (Fig. #3) Ensure

there are no leaks.

4. Attach spark electrode (ORANGE) and

sensor leads to the electrical bulk head.

(Fig. #4)

(The spark electrode connection is the

rearmost connector.)

NOTE:

If unit is to be converted to Propane, see Propane conversion instructions on

page 7 before proceeding.

NOTE: Plug the 4 vacant holes in the bottom of the  rebox with 1/2” screws,

as they are not required to attach this style of burner.

Black Diamond Burner Installation

INSTALL MANIFOLD ASSEMBLY

Fig #1

Fig #2

Fig #3

Fig #4

ATTACH MANIFOLD SUPPLY TUBE

ATTACH PILOT SUPPLY TUBE

ATTACH SPARK ELECTRODE

AND SENSOR LEADS