Installation guide
Packing the Chassis for Shipping
BlackDiamond X8 Series Switches Hardware Installation Guide
89
Figure 57: Installing a Module Blank
3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the module blank.
NOTE
Tighten the screws of each installed module blank before inserting additional modules or blanks.
Otherwise, you might unseat modules or blank front panels that you have not secured.
Packing the Chassis for Shipping
This section describes how to pack the BlackDiamond X8 chassis for shipment back to
Extreme Networks.
You need the following tools and materials to pack a BlackDiamond X8 series chassis:
● Original shipping cover for the front module slots
● Lifting handles that were shipped with the chassis
● Original shipping box and packing materials
● Screwdriver for ground lug screws
● Four rack-mounting screws for attaching the support brackets to the rack (if they have
been removed)
● #2 Phillips screwdriver for removing the chassis from the rack
● Nylon package strapping material and a crimping tool
Before you begin, set the pallet in a convenient, stable location near the equipment rack.
BDX_034