Installation guide

Chapter 7: BlackDiamond X8 Maintenance Procedures
BlackDiamond X8 Series Switches Hardware Installation Guide
86
Replacing an I/O Module
You need the following tools and equipment to replace a BlackDiamond X8 series module:
● ESD-preventive wrist strap
● #2 Phillips screwdriver
● Module blank panel if you are not replacing the module
Removing an I/O Module
To remove an I/O module;
1 Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the
metal end to the receptacle between the management module slots.
2 Disconnect network cables from the front of the module.
3 On each injector/ejector lever, turn the captive screw counter-clockwise until the yellow band
around the screw head of is completely visible (Figure 53).
Figure 53: Unlocking a Module
4 Squeeze the release latch on each injector/ejector handle and rotate both handles outward to
disconnect the internal module connectors (Figure 54).
Figure 54: Removing an I/O Module
BDX_038
BDX 027