Installation guide

Chapter 7: BlackDiamond X8 Maintenance Procedures
BlackDiamond X8 Series Switches Hardware Installation Guide
84
Installing a Management Module
To install the replacement management module:
1 Remove the module from the antistatic packaging.
CAUTION
To prevent ESD damage, hold the module by the metal rail and front panel only. Never touch the
components on the PCB or the pins on any of the connectors.
2 Verify that the injector/ejector handle is in the open position (Figure 51).
Keep the injector/ejector handle in the open position as you slide the module into the chassis slot.
3 Carefully slide the module into the slot until the injector/ejector handle engages the edge of the
chassis and begins to rotate toward the module.
4 Use the lever to fully seat the internal module connectors.
Figure 51: Installing a Management Module
5 Use a # 2 Phillips screwdriver to lock the handle into place (Figure 52).
When the locking screw is fully tightened, the yellow band around the screw head is completely
hidden.
CAUTION
Be careful to avoid over-torquing and stripping the screw head.
BDX_015