Installation guide

Chapter 7: BlackDiamond X8 Maintenance Procedures
BlackDiamond X8 Series Switches Hardware Installation Guide
80
c Carefully slide the module out of the switch chassis (Figure 45) and set it aside on an anti-static
surface.
Figure 45: Removing a Fabric Module
4 Install the replacement fabric module:
a Remove the module from the antistatic packaging.
a Loosen the screws on the insertion/extraction levers and open the levers.
b Align the circuit board with the guides at the top and bottom of the chassis and slide the module
into the chassis (Figure 46).
BDX_022