Installation guide

Chapter 7: BlackDiamond X8 Maintenance Procedures
BlackDiamond X8 Series Switches Hardware Installation Guide
74
Replacing a Power Supply
You need a #2 Phillips screwdriver to remove the power supply ventilation cover.
To replace a power supply:
1 Remove the power supply ventilation cover (Figure 37).
a Loosen the retaining screws at the top corners of the cover panel.
b Pull outward on the retaining screws to tilt the cover panel away from the front of the chassis.
c Lift the cover panel away from the chassis.
Figure 37: Removing the Power Supply Ventilation Cover
2 Push the release button for the inserter/extractor lever on the front of the power supply.
3 Rotate the inserter/extractor lever to the right to unseat the power supply from the internal
connectors.
4 Carefully slide the power supply out of the chassis and set it aside (Figure 38).
BDX_017