Installation guide

Unpacking the Chassis
BlackDiamond X8 Series Switches Hardware Installation Guide
49
3 Remove the support brackets and boxed accessories and set them aside until you need them
(Figure 15).
4 Lift off the upper packing foam. Pull apart the keyed corner of the lower packing foam and remove
the lower packing foam from around the chassis (Figure 15).
Figure 15: Removing the Accessories and Foam
5 On each side, remove the restraining bolts from the shipping brackets at the front and middle of the
chassis (Figure 16).
Figure 16: Unbolting the Chassis
6 Open the accessory box and locate the four lifting handles.
BDX_003
BDX_004