Specifications

ExtremeXOS 12.3.4 Release Notes
9
MM-17 is not yet operational
MM-17 is not yet operational
MM-17 is not yet operational
MM-17 is in Operational state
MM-17 node is BACKUP
MM-17 is not yet in-sync
MM-17 is in Operational state
MM-17 node is BACKUP
MM-17 is not yet in-sync
MM-17 is in Operational state
MM-17 node is BACKUP
MM-17 is not yet in-sync
MM-17 is in Operational state
MM-17 node is BACKUP
MM-17 is not yet in-sync
MM-17 is in Operational state
MM-17 node is BACKUP
MM-17 node is IN-SYNC
MM-17 was installed successfully
Installing firmware...
DEFERRED: SLOT 18, PFC uC Primary image
DEFERRED: SLOT 18, Tesla uC Primary image
SUCCESS: SLOT 18, PFC uC Primary image
..................
History
This command was first available in ExtremeXOS 12.3.4.
Platform Availability
This command is available only on BlackDiamond 20808 switches.
Feature Enhancements in ExtremeXOS 12.3.3
This section lists the feature enhancements supported in ExtremeXOS 12.3.3 software:
● Legacy CLI
The Legacy Command Line Interface (CLI) feature enables those who have experience with legacy,
mode-based CLIs to use familiar commands to start using the ExtremeXOS software using
commands they already know. The Legacy CLI feature is distributed in a modular software package
called an xmod file, which must be acquired separately from the ExtremeXOS software.
The Legacy CLI feature enables configuration of most Layer 2 ExtremeXOS software features in
Legacy CLI sessions. To configure Layer 3 features and any features not supported by Legacy CLI
sessions, you must use the Extreme standard CLI session.
See the ExtremeXOS Legacy CLI Quick Reference Guide for more details.
● Summit
®
X650 SummitStack Using VIM1-SummitStack512 Guidelines
Before deploying a new stack with Summit X650 switches, consider the following guidelines: