Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.3.4 Release Notes
86
Resolved Issues in ExtremeXOS 12.3.4-patch1-1
The following issues were resolved in ExtremeXOS 12.3.4-patch1-1. The numbers shown in column one
of the following table are for internal reference and can be ignored. ExtremeXOS 12.3 includes all fixes
up to and including ExtremeXOS 11.1.4.4, ExtremeXOS 11.2.3.3, ExtremeXOS 11.3.4.5,
ExtremeXOS 11.4.4.7, ExtremeXOS 11.5.2.10, ExtremeXOS 11.6.5.3, ExtremeXOS 12.0.5,
ExtremeXOS 12.1.4, and ExtremeXOS 12.2.2-patch1-12. For information on those fixes, see the release
notes for the specific release.
PD4-1141415551 Software redundant ports become active for a short period of time after performing a
save and rebooting the switch.
PD4-1409631701,
PD4-334620931
During an MSM or MM failover, an MSDP peer incorrectly prints debug messages in the
log as warning messages.
PD4-1571416747,
PD4-1562364701
When the udp-profile is used to forward traffic to a destination-ipaddress, a memory leak
is observed in ip_dst_cache.
SummitStack
PD4-1519887901,
PD4-1354693709
In a SummitStack configuration, the switch sends the wrong SNMP traps when the link
status of a stacking port changes.
PD4-1374144318 In a SummitStack, when a master node goes down, ELSM status in the neighboring
switch goes to a "down" state.
EAPS
PD4-1102733442 You cannot delete EAPS domains that use the same name but are created using
different upper and lower case characters, for example, E777 and e777.
PD4-1206057921 If EAPS ring ports are added to a VLAN before protecting the VLAN from EAPS, the
EAPS secondary port may not be blocking the protected VLAN.
OSPF
PD4-1509196737,
PD4-1059134755
An AS external route with a lower type-2 path cost is preferred regardless of whether the
originated ASBR is reachable through intra-area or inter-area paths.
RIP
PD4-1137714021 A RIP routing entry with a metric of 16 shows in the routing table as Active.
ScreenPlay
PD4-1523522225,
PD4-752945069
If the execCLI XML API is run with specifc commands such as top or edit on an
ExtremeXOS switch, the switch becomes unresponsive.
Table 41: Platform-Specific and Feature PDs
PD Number Description
General
PD4-657839005 When stacking redundancy is disabled, the following error message is displayed after
executing the save command followed by enabling SSH:
<Info:AAA.LogSsh> Slot-1: Msg from Standby Slot 3: Error -1 writing SSH info to System.
PD4-1350258611 Process exsshd consumes 99% of CPU capacity when executing the clear session
command.
Workaround: Restart the exsshd process to restore CPU utilization. You may also close
the SSH session properly using the logout or exit commands instead of the clear session
command.
Table 40: Platform-Specific and Feature PDs (Continued)