Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.3.4 Release Notes
70
PD4-761201951 In ExtremeXOS 12.3, if there is only a single MSM in an MSM-B slot, the 8900-G96T-c
and 8900-10G24X-c I/O modules may reset a couple of times before becoming
operational. This issue may occur when:
• The chassis reboots
• These I/O modules are disabled and enabled
• The I/O modules are inserted into the chassis
PD4-758181807 Non-combo ports with a 10/100/1000BASE-T SFP inserted in a switch with a link up, flap
if any other two ports are disabled.
Workaround: Disable ports one at a time.
PD4-730820249 If a route prefix is more than 24, only 100,000 routes are stored in the hardware. For the
route prefixes less than 24, then 512,000 routes are stored in the hardware.
PD4-749060484 Errors are seen when a configuration having identifiers (SNMPv3 user name/EAPS
domain name) with special characters are loaded through a script.
PD4-757870353 Running diagnostics on the master MSM generates errors such as subsection reported
as failed, conduit errors, and HAL.IPv4FIB/HAL.IPv6FIB. These log messages do not
appear to have any impact on the successful completion of diagnostics on the master
MSM.
PD4-749280880 Installing firmware fails and displays the following message:
tftp: server says: Wrong TFTP State
PD4-718946965 Directed broadcast traffic is not being forwarded.
PD4-740255437 Policy files are not refreshed when generating 30,000 rules.
PD4-734160746 In a private VLAN spanning two switches, when one of the switches has loopback-port
configured and the network VLAN port between the switches is a load-shared port, if the
loopback port is deleted and later re-added, the first packet received in the member port
can be dropped. Subsequent packets are forwarded correctly.
PD4-749682632 You cannot run the configure port auto on command on XGM2-2bt ports.
PD4-717942168 FDB entries are not learned for L2 broadcast traffic after an MM failover.
PD4-722565502 Hot insert of a PSU or reseating an AC plug on a PSU causes the following error
messages on a BlackDiamond 20800 series switch and causes the show power
budget command to read the wrong value for the PSU.
* BD-20804.25 #
########### CRITICAL ERROR
devmgr: dmps.c:563: power_add(): REASON: total->volt[i] == p2-
>volt[i]
* BD-20804.26 # show power budget
Watts
PS State at 48V
--------------------------------------------
1 Powered On 2340.00
2 Powered On 3480.00
3 Powered On 6960.00
PD4-733230780 MAC security does not work on a PVLAN.
PD4-646084932 An FDB entry for a non-isolated VLAN is not show in the output of the show fdb
command after disabling and enabling an I/O module.
PD4-742951283 An I/O slot fails due to a Tx data memory overflow and generates the following error
message:
<Erro:HAL.Card.Error> MSM-A: skylerHC-1184: skyler12 on slot 1 (4
errors):TX Data Memory Overflow: reg 0x32 value 0x01000001 wanted
(0x00000000) got (0x01000000)
Table 38: Platform-Specific and Feature PDs (Continued)
PD Number Description