Specifications

ExtremeXOS 12.3.4 Release Notes

NOTE

All four physical stack ports must be connected per the cabling guidelines in the VIM1 module

installation note included in your VIM1 shipment. The ports must be operational in order to function properly.

* Slot-2 Stack.1 # show slot

Slots Type Configured State Ports

--------------------------------------------------------------------

Slot-1 X650-24t(SS512) Operational 24

Slot-2 X650-24x(SS512) Operational 24

Slot-3 Empty 0

Slot-4 Empty 0

Slot-5 Empty 0

Slot-6 Empty 0

Slot-7 Empty 0

Slot-8 Empty 0

* Slot-2 Stack.2 # show stacking

Stack Topology is a Ring

Active Topology is a Ring

Node MAC Address Slot Stack State Role Flags

------------------ ---- ----------- ------- ---

*00:04:96:35:9d:55 2 Active Master CA-

00:04:96:1e:a8:02 1 Active Backup CA-

* - Indicates this node

Flags: (C) Candidate for this active topology, (A) Active Node

(O) node may be in Other active topology

* Slot-2 Stack.3 # show stacking stack-ports

Stack Topology is a Ring

Slot Port Node MAC Address Port State Flags Speed

---- ---- ----------------- ----------- ----- -----

*2 1 00:04:96:35:9d:55 Operational CB 128G

*2 2 00:04:96:35:9d:55 Operational C- 128G

1 2 00:04:96:1e:a8:02 Operational C- 128G

1 1 00:04:96:1e:a8:02 Operational CB 128G

* - Indicates this node

Flags: (C) Control path is active, (B) Port is Blocked

● Connect stacking cables between two VIM1-SummitStack512 modules as follows:

- Stack port 1 to stack port 1

- Stack port 2 to stack port 2

- Stack port 3 to stack port 3

- Stack port 4 to stack port 4

Any other connection order could result in an incorrect stacking topology and cause a non-

deterministic traffic routing between the two Summit X650 series nodes.

Feature Enhancements in ExtremeXOS 12.3.1

This section lists the feature enhancements supported in ExtremeXOS 12.3.1 software: