Specifications

ExtremeXOS 12.3.4 Release Notes
103
ACL
PD4-773570063,
PD4-629923298
If a dynamic ACL is applied to ingress and egress to two or more interfaces (port or VLAN),
the configure access-list delete all command does not delete the dynamic ACL from all
interfaces.
Workaround: Manually delete the dynamic ACL from each port or VLAN using one of the
following commands:
configure access-list delete ping port <port-list>
configure access-list delete ping vlan <vlan-name>
PD4-762092248,
PD4-667212313
If the refresh policy command is invoked by adding more entries to the policy file,
then after unconfiguring that specific ACL, an ExtremeXOS switch starts logging messages
such as:
Denied packet on ingress interface vlanIf=1000223 slot=1 port=1,
too many ACL's & packet rate is too high" and start to drop all
the packets received in slow path.
PD4-778918022,
PD4-738207292
Access-profile configurations for SNMP and SSH modules are not available in the show
configuration command output.
PD4-778918166,
PD4-641467077
The telnetd process crashes with signal 11 when the same policy file is used in a telnet
access-profile and an ACL.
CLEAR-Flow
PD4-818833708,
PD4-512656071
A HAL process crash occurs when HQoS is used with CLEAR-Flow and CLEAR-Flow rules
are enabled.
DHCP
PD4-779435690,
PD4-717000351
An error message should be displayed when adding a subVLAN to a superVLAN if DHCP
client or BOOTP client is enabled on the subVLAN.
EAPS
PD4-770418764,
PD4-682475164
IPv6 neighbor discovery packets sent to the CPU are affecting EAPSv2 PDUs, resulting in
the following message:
EAPS Shared Port: Segment timer expired.
PD4-778445090,
PD4-627092945
When a shared port is configured prior to enabling an EAPS domain, the EAPS protected
VLAN does not block the secondary port in some cases.
ESRP
PD4-775116218,
PD4-631761683
When ESRP is disabled, clients using an ESRP virtual IP address as a default gateway are
not able to communicate outside the VLAN.
Network Login
PD4-770418608,
PD4-684538103
Running the save configuration command causes a memory leak in the netlogin
process.
OSPF
PD4-778086791,
PD4-707855673
OSPF stops translating external routes after deleting a static route to the same destination
IP address.
PD4-760942817,
PD4-759590041
After a port in a VLAN is added to an OSPF area, it takes about four seconds to update a
neighboring switch.
PoE
PD4-779393568,
PD4-717931715
After upgrading a PoE capable ExtremeXOS switch from software version ExtremeXOS
11.6 to 12.1, the show configuration poe command is not available.
PD4-779435653,
PD4-707855726
The configure inline-power budget command is not supported on Summit family
and SummitStack switches.
Table 48: Platform-Specific and Feature PDs (Continued)
PD Number Description