Instructions / Assembly

TOP

SHELF

A / C C O R P O R AT I O N

INSTALLATION INSTRUCTIONS

Requires No Drilling, Tools,

Fasteners or Hardware

(For Single, Double Hung Windows Only. Sizes 24”-38” wide.)

CAUTION:

445 Broad Hollow Road, Suite 25 • Melville, NY 11747

1-866-503-0277 • www.topshelfac.com

TOP

SHELF

A / C C O RP O R A T IO N

Before You Keep Cool...

Read the enclosed instructions to ensure the safe and

proper method of installing the TopShelf A/C Bracket

Make sure the width of the window is no less than 24

inches and greater than 38 inches

Install the TopShelf A/C Bracket from inside

Not for use on dormers. Ensure there is Ten inches

of clearance below window

Do not fully lean out of window

Do not overload the TopShelf A/C Bracket in excess

of its maximum capacity to 200 pounds

To ensure a proper t, place one clip on the bottom

of each side curtain and attach to the left and right

wings to help secure side curtains in place

There might be occasions when objects such as

awnings, signage, lighting and masonry structures

below a window may obstruct and prevent the proper

installation of the TopShelf A/C Bracket

The TopShelf A/C Bracket does not reduce, eliminate

or mitigate the requirements of any air conditioner

manufacturer in the mounting and installation

thereof

Model TSB-2438 - Form 14.05.27

PAGE 1
CAUTION: Before You Keep Cool... TOP SHELF A / C C O R P O R AT I O N 1. Read the enclosed instructions to ensure the safe and proper method of installing the TopShelf A/C Bracket INSTALLATION INSTRUCTIONS 2. 3. 4. 5. 6. 7. Make sure the width of the window is no less than 24 inches and greater than 38 inches (For Single, Double Hung Windows Only. Sizes 24”-38” wide.) Install the TopShelf A/C Bracket from inside Not for use on dormers.
PAGE 2
TOP 3 EASY STEPS SHELF A / C C O R P O R AT I O N Optional Clip Installation Step 1 Place bracket upside down. Attach Legs: Slide leg into support rail while pressing BOTH spring buttons. Release button so that it extends out from the inner or outer hole of support rail. Repeat for second leg. It’s advisable to initially use the third hole (See Illustration).