Instruction Manual

5
ENGLISH
(Original instructions)
h. Keep handles and grasping surfaces dry, clean and
free from oil and grease. Slippery handles and grasping
surfaces do not allow for safe handling and control of the
tool in unexpected situations.
5. Battery tool use and care
a. Rechargeonlywiththechargerspeciedbythe
manufacturer. A charger that is suitable for one type of
batterypackmaycreateariskofrewhenusedwith
another battery pack.
b. Usepowertoolsonlywithspecicallydesignated
battery packs. Use of any other battery packs may create
ariskofinjuryandre.
c. When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause burns
orare.
d. Underabusiveconditions,liquidmaybeejectedfrom
the battery; avoid contact. If contact accidentally
occurs,ushwithwater.Ifliquidcontactseyes,
additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
e. Do not use a battery pack or tool that is damaged or
modied.Damagedormodiedbatteriesmayexhibit
unpredictablebehaviourresultinginre,explosionorrisk
of injury.
f. Donotexposeabatterypackortooltoreor
excessive temperature. Exposuretoreortemperature
above 130 °C may cause explosion.
Note: The temperature „130 °C“ can be replaced by the
temperature „265 °F“.
g. Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
speciedintheinstructions.Charging improperly or
 attemperaturesoutsidethespeciedrangemaydamage
thebatteryandincreasetheriskofre.
6. Service
a. Haveyourpowertoolservicedbyaqualiedrepair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
b. Never service damaged battery packs. Service of
battery packs should only be performed by the
manufacturer or authorized service providers.
Additional power tool safety warnings
@
Warning! Additional safety warnings for screw-
drivers.
u Hold the power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
u Wear ear protectors with impact drilling. Exposure
to noise can cause hearing loss.
u Use clamps or another practical way to secure and
support the work piece to a stable platform. Holding
the work by hand or against your body leaves it unstable
and may lead to loss of control.
u Beforedrivingfastenersintowalls,oorsorceilings,
check for the location of wiring and pipes.
u The intended use is described in this instruction
manual.
u The use of any accessory or attachment or
performance of any operation with this tool other than
those recommended in this instruction manual may
present a risk of personal injury and/or damage to
property.
Safety instructions when using long drill bits
u Never operate at higher speed than the maximum
speed rating of the drill bit. At,higher speeds, the bit is
likely to bend if allowed to rotate freely without contacting
the workpiece, resulting in personal injury.
u Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher speeds,
the bit is likely to bend if allowed to rotate freely without
contacting the workpiece, resulting in personal injury.
u Apply pressure only in direct line with the bit and do
not apply excessive pressure. Bits can bend causing
breakage or loss of control, resulting in personal
injury.
Safety of others
u This tool is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
u Children should be supervised to ensure that they do not
play with the appliance.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include: