User Manual

20
PROBLEM POSSIBLE CAUSE SOLUTION
Display
flashes 3
blinking bars
but timer
doesn’t start
Working
pressure
isn’t
reached
inside
during
preheating
cycle
Pressure
release valve
is not in the
seal position
Check if pressure
release value is
turned to the seal
position
Rubber
gasket is not
in place
Install the rubber
gasket correctly
Red interlock
pin with
rubber
retainer ring
on bottom of
lid is not in
place
Check that red
interlock pin is
installed with the
rubber retainer ring
on the bottom of lid
Display flashes
“C5” and the
pressure cooker
shuts down
Overheating is detected on
the cooking bowl
Stop
the program,
use the pressure
release valve to
reduce the internal
pressure and check
if the food at the
bottom of the
cooking bowl is burnt
Display remains
blank after
connecting the
power cord
Bad power connection or
no power
Inspect the power
cord to ensure a
good connection,
check that the power
outlet is active
Appliance electrical issue Contact the
consumer service
team
All LEDs
flash with
a code
appearing
on screen
C1
code
Faulty temperature sensor
(cannot be detected)
Contact the
consumer service
team
C2
code
Faulty temperature sensor
(short circuited)
C5
code
Temperature is too high
because cooking bowl is
not in the pressure cooker
Temperature is too high
because there is no water
in cooking bowl
C6
code
Faulty pressure sensor