User guide

1515
A
B
A
A
B
A
Beam Positioning
Clamping Procedure
Template Positioning
R9PLUS BENCH OPERATION
CHAPTER 4
Basic Jig Functions
Beam Positioning
4-1 The beam assembly is clamped in position with the front
edge
A
slightly overhanging the bench front and the active comb
of the template
B
facing the operator.
4-3 Squeeze the tips of the clamp locator
A
and insert through
a clamp hole in the beam. Clamp locators hold the clamp arm
firmly in place while the clamp’s screw arm is attached from the
opposite side of the beam.
Clamping Procedure
4-2 Each of the F-Clamps included with the R9 PLUS is fitted
with a clamp locator
A
. The clamp locators are pressed onto the
clamp arm and should not be removed.
4-4 Boards are always clamped against the sidestop
A
and flush
under the template
B
.