KA89E
English 2 (Original instructions) 5
A B C D E F 3
G 4
Intended use Your Black & Decker sander has been designed for sanding wood, metal, plastics and painted surfaces. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5. Service a.
Labels on tool : The following pictograms are shown on the tool: Warning! To reduce the risk of injury, the user must read the instruction manual. Electrical safety # This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. Retracting the hood (fig. D) The hood can be retracted for sanding in confined spaces. Warning! The hood can only be retracted when the adjustable handle is in the up position.
Warning! Do not twist the filter. u Shake off excess dust by tapping the filter into a dustbin. Warning! Do not brush or use compressed air or sharp objects to clean the filter. Do not wash the filter. u Replace the filter. u Refit the cover. u Refit the dust cassette onto the tool. Hints for optimum use u u u u u u u Always hold the tool with both hands. Do not exert too much pressure on the tool. Regularly check the condition of the sanding belt. Replace when necessary.
EC declaration of conformity % MACHINERY DIRECTIVE KA89E Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60745-1, EN 60745-2-4 For more information, please contact Black & Decker at the following address or refer to the back of the manual. _ The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90563160 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
