Operating Guide

ENGLISH
5
Figure D
9
2
10
Attaching a cleaning pad - Fig. E
Replacement cleaning pads are available from your
BLACK+DECKER dealer (cat. no. SMP20).
• Place a micro-fiber cleaning pad
21
on the floor with
the ‘hook & loop’ side facing up.
• Press steam mop down onto the cleaning pad. You are
now ready to steam clean and sanitize your floor.
NOTICE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle tube
6
in the upright position when stationary and make sure the
steam mop is turned off and unplugged when not in use.
Figure E
29
21
Removing a cleaning pad - Fig. E

CAUTION: Always wear suitable shoes when
changing the cleaning pad on your steam mop. Do
not wear slippers or open-toed footwear.
1. Return the handle tube
6
to the upright position and
turn the steam mop ‘OFF’.
2. Wait until it cools down. (approximately five minutes)
3. Place the front of your shoe onto the cleaning pad
removal tab
29
and press down firmly.
4. Lift the steam mop up off the cleaning pad.
NOTICE: Do not store with a wet pad as this can damage
your floor. Always place the steam mop with the handle tube
6
in the upright position when stationary and make sure the
steam mop is turned off and unplugged when not in use.
Hand-held steam cleaner attachments
NOTICE: Remove the hand-held steam cleaner from the
steam body after turning off and unplugging the steam
mop, and after allowing the steam mop to cool down.
Attaching the hose and steam glove -
Fig. F
1. Firmly press the hose (
11
or
14
) onto the steam nozzle
of the hand-held steam cleaner such that it is fully
seated.
2. To remove, depress the hose release button
30
, and
pull the hose out of the hand-held steam cleaner.

WARNING: Inspect the seal
31
on the
handheld steam cleaner
2
and the seal
32
at
the end of the hose before each use (figure F).
If the seal is missing or damaged contact your
nearest authorized repair agent. Do not use the
appliance.

CAUTION: En sure that the hose is securely
fastened before using the hand-held steam cleaner.
Figure F
32
30
11
31
ATTACHING OTHER ACCESSORIES TO
THE HOSE - Fig. G
1. For other accessories other than the steam nozzle, align the
lugs
31
on the hose with the recesses on the accessory.
2. Press the accessory onto the hose and twist clockwise until
the accessory is fully seated and clicks into place.
Figure G
31
Attaching steam jet nozzle - Fig. H
1. Press in the clips
32
on the steam jet nozzle
24
.
2. Align the two keys on the inside flange of the steam jet
nozzle with the two slots at the end of the hose
11
.
3. Firmly press the steam jet nozzle onto the hose such that
it is fully seated, and release the clips.
4. To remove, press the clips and pull the steam jet nozzle
away from the hose.

WARNING: Inspect the seal on the steam nozzle of the
hose before each use (figure H). If the seal is missing or
damaged contact your nearest authorized repair agent.
Do not use the appliance.

CAUTION: Ensure that the hose and/or steam nozzle
is securely fastened before using the hand-held steam
cleaner.
Figure H
32