HPL10RS
A B C D 2 E
F G H I J 3
ENGLISH (Original instructions) Intended use Your Black & Decker hand-held saw has been designed for sawing wood, plastics and sheet metal. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
(Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
ENGLISH u u u u u (Original instructions) Injuries caused by touching any rotating/moving parts. Injuries caused when changing any parts, blades or accessories. Injuries caused by prolonged use of a tool. When using any tool for prolonged periods ensure you take regular breaks. Impairment of hearing. Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.
(Original instructions) Assembly Warning! Before assembly, remove the battery from the tool and make sure that the saw blade has stopped. Used saw blades may be hot. Warning! To prevent loss of control, never use tool without shoe. Fitting and removing the battery (fig. E) u Fitting the saw blade (fig. B) Hold the tool away from the body Rotate the blade clamp collar (8) to the release position. u Insert the shank of the blade fully into the blade clamp collar (8).
ENGLISH (Original instructions) Re-insert the battery (5). If the charging indicators continues flashing red at a fast rate, use a different battery to determine if the charging process works properly. u If the replaced battery charges correctly, the original battery is defective and should be returned to a service centre for recycling. u If the new battery gives the same indication as the original battery, take the charger to be tested at an authorised service centre.
ENGLISH (Original instructions) Blades The saw will accept a blade up to 30 cm long. Always use the shortest blade suitable for your project but long enough to keep the blade cutting through the material. Longer blades are more likely to be bent or damaged during use. During operation some longer blades may vibrate or shake if the saw is not kept in contact with the workpiece. Maintenance Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance.
ENGLISH (Original instructions) EC declaration of conformity % MACHINERY DIRECTIVE HPL10RS Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60745-1, EN 60745-2-11 For more information, please contact Black & Decker at the following address or refer to the back of the manual. The undersigned is responsible for compilation of the technical _ file and makes this declaration on behalf of Black & Decker.
E16236 6 5 1 www.2helpU.com 3 HPL10RS 7 2 13 - 11 - 10 4 H1 TYP.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel. 01753 511234 Fax 01753 551155 ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.
