GLC2500L
English 2 (Original instructions) 4
A B C D E F 3
G H I J K 4
L M N 5
Intended use Your Black & Decker strimmer has been designed for trimming and finishing lawn edges and to cut grass in confined spaces. This tool is intended for consumer use only. Your Black & Decker charger has been designed for charging Black & Decker batteries of the type supplied with this tool.
u u u u u u Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. Never attempt to charge non-rechargeable batteries. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid hazard. Do not expose the charger to water. Do not open the charger. Do not probe the charger.
Assembly Warning! Before assembly, remove the battery from the tool. Fitting and removing the battery (fig. B) u u To fit the battery (14), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. To remove the battery, push the release button (17) while at the same time pulling the battery out of the receptacle. Assembling the guard (fig. C) u u u Place the pin (18) of the guard into the hole (19).
u Charge discharged batteries within 1 week. Battery life will be greatly diminished if stored in a discharged state. Charging indicators If the charger detects a problem with the battery, the charging indicator (16) will flash at a fast rate. Proceed as follows: u Re-insert the battery (14). u If the charging indicators continues flashing at a fast rate, use a different battery to determine if the charging process works properly.
Maintenance Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. Your charger does not require any maintenance apart from regular cleaning. Warning! Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before cleaning it. u After use disconnect the battery and check the tool for any damage.
EC declaration of conformity You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are available on the Internet at: www.2helpU.com MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE % Batteries Black & Decker batteries can be recharged many times.
Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90560493 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
