GL544 GL545 1
Copyright Black & Decker 2
4 3 2 7 5 1 6 8 10 5 6 9 1 3
2.1 10 2.3 2.2 2.
3.1 4 5 15 19 16 18 9 17 6 MAX 21 7.1 20 7.2 3.2 22 7.
Grass Trimmer Congratulations! Your purchase of this Black & Decker Reflex® grass trimmer and lawn edger assures you of years of problem free trimming. The Reflex® not only trims grass and edges the lawn, it also has a unique totally automatic line feed system. You do nothing the Reflex® system means non-stop trimming; by the use of a simple mechanism it senses when the line has worn and, when needed, automatically feeds out line to its optimum cutting length. You just switch the unit on and trim.
ENGLISH Cutting line • Take care against injury from line trimming blade (8) during unpacking and assembly and any excess line which may be cut off when the trimmer is first operated. • The cutting line (9) will continue to run for a short time after releasing the trigger switch. Under no circumstances should you attempt to stop the cutting line, always allow it to stop on its own. • Never fit metal cutting line. t Using your machine • Always use your machine in the manner outlined in this manual.
• • Only fit 13 amp BS1363A approved plugs fitted with the correctly rated fuse. The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Attach the wires to their respective points in the plug (see below). Brown is for 'Live' (L) and blue is for 'Neutral' (N). Warning! The use of an RCD or other circuit breaker unit does not release the operator of the machine from the safety instructions and safe working practices given in this manual.
A B C D E F G H J ENGLISH Do not use your trimmer without its guard. Do not cut wet grass; best results are achieved when the grass is dry. Trimming • To switch on your trimmer, squeeze the trigger switch (3). • To switch the unit off, release the trigger switch. • To carry the trimmer when not in use, it is preferred that you use the secondary handle (2). Cut at an angle and with the tip of the cutting line (9). Swing the trimmer gently from side to side. Do not overload the trimmer.
How to wind new line onto an empty spool (Fig. 6 & 7) • A maximum of 10 metres of new cutting 6 • • • • • • line can be wound onto the empty spool. The spool has an ‘Indicator’ to help you avoid winding an excessive quantity of cutting line on the spool, as too much will prevent the automatic feed system from functioning. Remove any remnant of old cutting line from the spool (19). Push the end of the new cutting line into one of the two retaining holes (21) provided in the spool (19) and insert 20mm.
ENGLISH You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are available on the Internet at: www.2helpU.com. Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee.
TYP.
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker 81 Hugo Johnston Drive Penrose, Auckland, New Zealand United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 808876-08 Tel. 09 579 7600 Fax 09 579 8200 Tel.
