GL280 GL301 GL315 GL337 GL350
English 2 (Original instructions) 6
A B C D E F 3
G H I J K L 4
M N O 5
Intended use Residual risks. Warning! When using mains-powered appliances, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock, personal injury and material damage. u Read all of this manual carefully before operating the appliance. u The intended use is described in this manual.
u u u u u u u u u u u u u u u u u u u u u Before use, check the power supply cord and extension cord for signs of damage, ageing and wear. If a cord becomes damaged during use, disconnect the cord from the mains supply immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY. Do not use the appliance if the cords are damaged or worn. Wear stout shoes or boots to protect your feet. Wear long trousers to protect your legs.
u Secure the guard with the screw. Warning! Never use the tool unless the guard is properly fitted. Releasing the cutting line In transit, the cutting line is taped to the spool housing. u Remove the tape holding the cutting line (11) to the spool housing (12). Connecting the tool to the mains (fig. D) Connect the female plug of a suitable extension cable to the power inlet (4). u Loop the cable through the cable restraint (3). u Insert the mains plug into a mains outlet.
Remove the empty spool (23) from the spool cover. Remove any dirt and grass from the spool cover and housing. u Take the new spool and push it onto the boss in the spool cover. Rotate the spool slightly until it is seated. u Unclip the end of one of the cutting lines and feed the line into one of the eyelets (24). The line should protrude approximately 9 cm from the spool cover. u Unclip the end of the other cutting line and feed the line into the other eyelet.
u Remove the spool and unwind the cutting line, then wind it on neatly again as described above. Replace the spool as instructed. Maintenance Your Black & Decker corded/cordless appliance/tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool/appliance care and regular cleaning. Warning! Before performing any maintenance on corded/ cordless power tools: u Switch off and unplug the appliance/tool.
EC declaration of conformity MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE % GL280/GL301/GL315/GL337/GL350 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60335-1, EN 60335-2-91 2000/14/EC, Lawn Trimmer, L ≤ 50 cm, Annex VIII KEMA Quality B.V., Utrechtseweg 310, 6802 ED Arnhem, The Netherlands Notified Body ID No.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90553705 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
