www.blackanddecker.com.
9 3
Intended use ENGLISH Your Black & Decker AlligatorTM Lopper has been designed for trimming the branches of trees, cutting fallen branches and cutting small logs 25 mm to 100 mm in diameter while the operator is standing on the ground. This tool is intended for consumer use only. Safety instructions General power tool safety warnings Warning! Read all safety warnings and all ! instructions. Failure to follow all instructions may result in electric shock, fire and/or serious injury.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f.
Keep your saw chain properly tensioned. Check tension at regular intervals with the motor stopped and cord disconnected. Begin and continue cutting only with the chain moving at full speed. Watch for shifting branches or other forces that could close a cut and pinch or fall into the chain. Use extreme caution when re-entering a previous cut. Engage spikes on lower jaw into wood and allow the chain to reach full speed before proceeding with cut.
Charge only at ambient temperatures between 10 °C and 40 °C. Charge only using the charger provided with the appliance/tool. Using the wrong charger could result in an electric shock or overheating of the battery. When disposing of batteries, follow the instructions given in the section "Protecting the environment". Do not damage/deform the battery pack either by puncture or impact, as this may create a risk of injury and fire. Do not charge damaged batteries.
and chain access cover retention bolts before use and adjust if required. Checking and adjusting the saw chain tension (fig. C) To tension the saw chain (14) slacken the two chain cover retention bolts (12) with the spanner (13) and the chain tensioning device will push the chain guide bar (3) out, setting the correct tension. Retighten the two retention bolts (12) securely. Check the correct tension has been set by lightly pulling on the saw chain (14).
(charging state) as the charger occasionally ‘tops off’ the battery charge. The charging indicator will be lit as long as the battery pack is connected to the plugged in charger. Charge discharged batteries within 1 week. Battery life will be greatly diminished if stored in a discharged state. Charge indicators If the charger detects a problem with a battery pack, the charge indicator will flash at a fast rate. If this occurs, re-insert the battery pack (6).
Cleaning Regularly remove the chain access cover (11) and remove any debris that has become trapped. Regularly clean the ventilation slots with a clean, dry paint brush. To clean the tool, use only mild soap and a damp cloth. Never let any liquid get inside the tool and never immerse any part of the tool into liquid. Oiling Regularly oil the oiling points (15) as indicated in figure D. Transport Always transport the tool with the jaws closed and the latch (5) in the locked position.
Technical data GKC1000L-XE 18 1.9 100 3.1 Voltage Chain speed (No-load) Maximum diameter of cut Weight Vdc m/min mm kg Battery Voltage Capacity Weight BL1518 Vdc 18 Ah 1.5 kg 0.38 Charger Voltage Output Voltage Current 90581219 typ.1 Vac 230 Vdc 20 A 2.
Australia Black & Decker (Australia) Pty. Ltd. 82 Taryn Drive, Epping Vic, 3076, Australia New Zealand Black & Decker 90582093 Tel. 1800 444 224 Tel.
