www.blackanddecker.co.
English 2 (Original instructions) 9
7 7
Intended use ENGLISH Your Black & Decker AlligatorTM Lopper has been designed for trimming the branches of trees, cutting fallen branches and cutting small logs 25 mm to 100 mm in diameter while the operator is standing on the ground. This tool is intended for consumer use only. Safety instructions General power tool safety warnings Warning! Read all safety warnings and all ! instructions. Failure to follow all instructions may result in electric shock, fire and/or serious injury.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f.
Keep your saw chain properly tensioned. Check tension at regular intervals with the motor stopped and cord disconnected. Begin and continue cutting only with the chain moving at full speed. Watch for shifting branches or other forces that could close a cut and pinch or fall into the chain. Use extreme caution when re-entering a previous cut. Engage spikes on lower jaw into wood and allow the chain to reach full speed before proceeding with cut.
Charge only using the charger provided with the appliance/tool. Using the wrong charger could result in an electric shock or overheating of the battery. When disposing of batteries, follow the instructions given in the section "Protecting the environment". Do not damage/deform the battery pack either by puncture or impact, as this may create a risk of injury and fire. Do not charge damaged batteries. Under extreme conditions, battery leakage may occur.
Checking and adjusting the saw chain tension (fig. C) To tension the saw chain (14) slacken the two chain cover retention bolts (12) with the spanner (13) and the chain tensioning device will push the chain guide bar (3) out, setting the correct tension. Retighten the two retention bolts (12) securely. Check the correct tension has been set by lightly pulling on the saw chain (14). The tension is correct when the saw chain snaps back after being pulled 3 mm away from the guide bar.
Preparation Carry out regular cleaning of the unit as described in the maintenance section and in particular cleaning inside the chain access cover (11). The lower jaw (2) and top jaw (1) are designed to close when one of the handles is released or when the piece of branch being cut has been cut. If this does not occur, discontinue use of the tool and remove the battery from the tool. Check if any debris is blocking movement.
Replacing worn out saw chains Protecting the environment Replacement saw chains are available through retailers or Black & Decker service agents. Always use genuine spare parts. Separate collection. This product must not be disposed of with normal household waste. Saw chain sharpness The saw chain cutters will blunt immediately if they touch the ground or a nail while cutting. Saw chain tension Regularly check the saw chain tension.
Technical data GKC1000 GKC1000P GKC1000NM H1 H1 H1 Vdc 18 18 18 Voltage Chain speed (No-load) m/min 1.9 Maximum diameter of cut mm 100 Weight kg 3.5 1.9 1.9 100 3.5 100 3.5 EC declaration of conformity MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE GKC1000 GKC1000P GKC1000NM Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN60745-1, 2000/14/EC, Chain Saw, Annex VI Battery A18 Input voltage Vdc 18 Output current A 1.2 Capacity Ah 1.
The product has been used for trade, professional or hire purposes. The product has been subjected to misuse or neglect. The product has sustained damage through foreign objects, substances or accidents. Repairs have been attempted by persons other than authorised repair agents or Black & Decker service staff. To claim on the guarantee, you will need to submit proof of purchase to the seller or an authorised repair agent.
E15144 806 9 13 6 10 12 Partial support - Only parts shown available Nur die aufgefuerten teile sind lieferbar Reparation partielle - Seules les pieces indiquees sont disponibles Supporto parziale - Sono disponibili soltanto le parti evidenziate Solo estan disponibles las peizas listadas So se encontram disponiveis as pecas listadas Gedeeltelijke ondersteuning - alleen de getoonde onderdelen zijn beschikbaar www.2helpU.com 11 GKC1000 3 14 24 - 08 - 09 1 H1 TYP.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
$XVWUDOLD %ODFN 'HFNHU $XVWUDOLD 3W\ /WG )OHWFKHU 5RDG 0RRURROEDUN 9LFWRULD 1HZ =HDODQG %ODFN 'HFNHU 7H $SXQJD 3ODFH 0W :HOOLQJWRQ $XFNODQG 8QLWHG .
