FSMH1621
A B C D E 2
F G H I J 3
K M 4 L
(Original instructions) Intended use Flexible hose and handle Your Black & Decker steam mop has been designed for sanitising and cleaning sealed hardwood, sealed laminate, linoleum, vinyl, ceramic tile, stone and marble floors and for refreshing carpets. This appliance is intended for indoor household use only. For convenient use of all accessories. Warning! Read all of the 'Safety, Maintenance, Service' manual carefully before operating this appliance.
ENGLISH (Original instructions) Attaching the hand held steam cleaner (Fig. C) Holding the back of the steam mop body (9) Push the hand held steam cleaner (5) firmly into the steam mop body (9) until it clicks into place. Caution! Always ensure the handle command lights up to confirm the unit is docked. Warning! Inspect that the seal (22 Fig. H) on the steam nozzle (4) before fitting the hand held steam mop to the steam mop body.
(Original instructions) Important! Ensure that the variable steam jet nozzle (27) is securely fastened before using the hand held steam cleaner. If steam escapes from the joint then the variable steam jet nozzle is not correctly fit, allow the unit to cool then remove and re-fit the variable steam jet nozzle. Attaching other accessories (Fig. H) u Align the lugs on the hose with the recesses on the accessory.
ENGLISH (Original instructions) Hints for optimum use General Caution! Never use the steam mop without first attaching a cleaning pad. u During steam mop use you can use the cable management clip (17) to keep your cable out of the way of the work area.. u Always vacuum or sweep the floor before using the steam mop. u The easiest way to use the machine is to tilt the handle to a 45˚ angle and clean slowly, covering a small area at a time. u Do not use chemical cleaners with your steam mop.
(Original instructions) please contact your nearest authorised repair agent. Do not use the appliance. If the seal is in good condition re-fit the hand held steam cleaner to the steam mop body ensuring that it is seated firmly in place. Caution! It is important to monitor the water level in the water tank. To refill the water tank and continue to sanitise/clean, return the handle (10) to the upright position and turn the steam mop ‘OFF’.
(Original instructions) ENGLISH Problem The steam mop is Step Possible solutions Problem Step Possible solutions 7 The steam mop will only produce steam Steam is escaping 22 Refer to the assembly chapter of the manual not producing once the handle is pulled back from the steam. upright position. 8 Check that the water tank (8) is full. NOTE: When first filled or after running dry it can take up to 45 seconds for steam to be produced.
TYPE FSMH1621 1 3 1 20 22 2 4 21 5 6 25 8 18 7 12 11 15 10 14 9 17 16 E16763 www.2helpU.
TYPE FSMH1621 - Accessories 1 1 3 2 5 4 6 E16765 www.2helpU.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90598593 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
