User guide

62 DISPLAY CONTENT MANAGER — Installation and User Guide
Section 2 — DCM Software Installation
11. Enter the folder path or click on the Browse button to browse for the
desired folder in which MediaEdge material (assets, content) are stored
on the server. These are the assets to be managed by the DCM.
Note In order to save disk space, it is recommended that the material (asset) path
be the same as the folder specified as the FTP content directory. See Con-
figure the FTP Server on page 44 for more information.
The Configure FTP Access dialog shown in Figure 45 appears.
Figure 45. Configure FTP Access Dialog
The FTP Server Name field will display the name of the Computer on
which the FTP server is installed.
Note This is the computer name on which the DCM is being installed as all com-
ponents are installed and configured on the same computer in this scenario.
12. Enter the FTP Server IP address in the IP Address field.
13. Enter the FTP Upload directory alias specified during FTP Server setup
(see
Configure the FTP Server on page 44 for more information) in the
Upload Directory field.
14. Click the Check Connect button to verify the connection to the FTP Server.
If the connection information is correct, the confirmation in Figure 46
appears.