www.blackanddecker.com.
A B C D E F 2
(Original instructions) Intended use Your Black & Decker screwdriver has been designed for screwdriving applications. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
ENGLISH (Original instructions) 3. Personal safety a. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. b. Use personal protective equipment. Always wear eye protection.
(Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
ENGLISH u u u Hold power tool by insulated gripping surfaces when performing an operation where the fastener may contact hidden wiring. Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
(Original instructions) Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated.
ENGLISH (Original instructions) Electrical safety # u Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Features This tool includes some or all of the following features. 1.
(Original instructions) The charger may hum and become warm while charging; this is normal and does not indicate a problem. Warning! Do not charge the battery at ambient temperatures below 10 °C or above 40 °C. Recommended charging temperature: approx. 24 °C. Low battery indicator When the battery charge becomes low the LED work light will begin to flash rapidly. u The LED Flash will last 5 seconds during Low voltage - - - - - at this pattern..
ENGLISH (Original instructions) Rotate the tool anti-clockwise and the screwdriver will activate in the reverse direction. Note: The speed of the tool is determined by the amount of rotation. . Small rotation = slower speed. Large rotation = Higher speed. u LED work light The LED work light (4) is activated automatically when the motion control activator (1) is depressed.
z (Original instructions) Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials. ENGLISH Technical data BDCS36G (H1) Voltage VDC 3.6 No-load speed Min-1 180 Max. torque Nm 3 Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or by the retailer when you purchase a new product.
ENGLISH (Original instructions) Statutory Warranties: Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Australia Black & Decker (Australia) Pty. Ltd. 82 Taryn Drive, Epping Vic, 3076, Australia New Zealand Black & Decker 90589059 REV-0 Tel. 1800 444 224 Tel.
