INSTRUCTION MANUAL THERMOPLASTIC SUBMERSIBLE SUMP PUMP BXWP62200 BXWP62300 Customer Support (855-222-3033) customer.service@pedrollo-usa.com. Please read before returning this product for any reason.
ENGLISH Index Content Page # Components 2 Safety Guidelines 3 Description 4 Specifications 4 Installation 5 Operation 6 Maintenance 6 Troubleshooting 7 Performance 8 Parts 9 Notes 10 Warranty 11 1 6 5 2 3 4 Components 1 Handle 2 1-1/4 in. (31.75mm) NPT Discharge 3 Motor 4 Base 5 Float Switch 6 1-1/4 in. (31.75mm) MNPT x 1-1/2 in. (38.1mm) MNPT or 1-1/4 in. (31.
Safety Guidelines ENGLISH Carefully read, understand and follow all safety instructions in this manual. Retain this manual for future reference. WARNING: Don’t expose the pump to freezing temperatures. Discharge lines exposed to freezing temperatures should be positioned with a downward slope to prevent freezing. This is the safety alert symbol. When you see this symbol, look for one of the following signal words.
ENGLISH Description This sump pump is designed to remove ground water from residential sump pits. The motor is oil cooled and hermetically sealed. A float switch is provided for automatic operation and is equipped with a 10 ft., 3-prong grounding type power cord. Specifications HP BXWP62200 BXWP62300 1/4 1/3 Volts 115 Volt AC 115 Volt AC Amps 3.8 4.0 Hz 60 60 Phase 1 1 1-1/4 in. (31.75mm) NPT or 1-1/4 in. (31.75mm) NPT or 1-1/2 in. (38.1mm) MNPT 1-1/2 in. (38.1mm) MNPT Max.
ENGLISH Installation WARNING: Always disconnect the power source before attempting to install, service or perform maintenance on the pump. Failure to do so may result in fatal electrical shock. NOTICE: Your pump is designed and built to give you reliable performance and long life. It will pump water automatically for years when properly installed in the right environment. NOTICE: A qualified electrician must perform all wiring. Remove old pump (if necessary): 1. Make sure power supply is disconnected. 2.
ENGLISH Operation Maintenance WARNING: The pump motor is thermally protected. It is not recommended for pumping liquids over 120° F (48,9° C). The thermal overload protector will automatically shut down the pump in an overheat situation. The pump will reset itself once the pump cools down. This overload is designed as a safety device and it will fail after repeated use. Normal operation is for fluids between 35°F - 120°F (1.7°C - 48.9°C). WARNING: Risk of electric shock.
ENGLISH Troubleshooting Problem If the pump does not start or run The pump starts and stops too often If the pump runs, but moves little or no water Pump does not shut off Possible Causes How To Correct Pump is not plugged in; switch or breaker is turned off Plug pump in or turn on switch/breaker Check for blown fuses or tripped circuit breakers or tripped GFCI outlets Replace fuse, reset circuit breaker, reset GFCI outlet Float switch is defective Check and replace if necessary Motor thermal
ENGLISH Performance Height and/or piping restriction will reduce the pump output performance. It is recommended to use the same size or larger pipe as the pump discharge for optimum performance. DISCHARGE HEIGHT ft/m 25ft / 7.62m 20ft / 6.1m Model Number BXWP62200 15ft / 4.6m BXWP62300 10ft / 3.05m 5ft / 1.52m 0 0 500 gal 1893 L 1000 gal 3785 L 1500 gal 5678 L 2000 gal 7571 L 2500 gal 9464 L GALLONS / LITERS PER HOUR Gallons Per Hour At Discharge Height Model 0 ft. 5 ft. 10 ft. 15 ft.
ENGLISH Replacement Parts For parts, contact customer support at 855-222-3033 or customer.service@pedrollo-usa.com. Reference Description BXWP62200 BXWP62300 1 Handle Assembly ABD300000 ABD300000 2 Shaft Seal C30010120 C30010120 3 Impeller 981040185 981040185 4 Gasket G81200134 G81200134 5 Base Assembly ABD300002 ABD300002 6 Adapter 981040005 981040005 * Motor Housing NA NA BXWP62200 BXWP62300 O10100001 O10100001 *If motor fails, replace entire pump.
ENGLISH Notes: 10
ENGLISH Limited Warranty: General Terms and Conditions - Cont: Manufacturer warrants the products specified in this warranty to be free from defects in material or workmanship for one (1) year from date of purchase. During the time period and subject to the terms and conditions, manufacturer will repair or replace to the original user or consumer any portion of this product which proves to be defective due to materials or workmanship.
Customer Support (855-222-3033) customer.service@pedrollo-usa.com Manufactured Under License By: Pedrollo Group Inc. 45 Maryland Ave East St. Paul, Minnesota 55117 Copyright ©2022 BLACK & DECKER, BLACK+DECKER, the BLACK & DECKER and BLACK+DECKER logos and product names and the orange and black color scheme are trademarks of The Black & Decker Corporation and are used under license. Product may differ from that pictured. Does not affect function.
