User Manual
Page 19
TO OPERATE TURBO
• Press the Function button, TURBO symbol flashes on
screen then press the function
button again, the TURBO
symbol will stop flashing and will illuminate on the LED screen
indicating that TURBO is activated.
TO CANCEL TURBO
• Press the Function
button, TURBO symbol flashes on screen then press
the function
button again, the TURBO symbol will stop flashing and will
no longer be illuminated in the LED screen indicating that TURBO function is
deactivated.
FOLLOW ME
Parts of the room are cooler where there is a draft. Other parts are warmer due
to direct sunlight. The FOLLOW ME Function allows the room to be cooled
according to the room temperature, wherever the remote is located.
• This function can be activated from the remote control ONLY. The remote
control serves as a thermostat allowing for the precise temperature control at
its location.
• To activate the Follow Me function, point the remote control towards the
appliance and press the FUNCTION
button.
• Press either the
OR button until the FOLLOW ME symbol ashes on
the LED screen.
• Press the Menu
button. The FOLLOW ME will stop ashing and illuminate
on the LED screen.
• The remote will display the actual temperature at its location. The remote
control will send this signal to the air conditioner at 20 minute intervals.
• If the unit does not receive the Follow Me/Temp Sensing signal during a 25
minutes interval, the follow me function will be canceled and will need to be
reactivated.
NOTE: · The remote must be within 23 feet of the remote control receiver on the
air conditioner unit. It should not have any obstructions.
• To cancel this function, press the
, then press either the or button
until the
ashes onscreen, and then press the button to conrm the
cancellation. The
will stop ashing and disappear from the screen.
SET UP & USE