Installation Guide

REMOVING THE DUST BOWL AND FILTERS (FIGURES E - H)

WARNING: The filters are re-usable and

should be cleaned regularly.

• Press the release latch and pull the dust bowl

straight off as shown in figure E.

• While holding the dust bowl over a bin or sink,

pull out the filter to empty the contents of the

bowl.

•

To replace the dust bowl, place it back onto the

handle until it “clicks” firmly into position.

WARNING: Never use the appliance

without the filters. Optimum dust collection will

only be achieved with clean filters.

• Figure F - This vacuum has a plastic pre-filter

and an inner cloth filter. To separate the cloth

filter from the plastic filter, twist the plastic filter in

a clockwise direction.

• Remove the inner cloth filter and shake or

lightly brush any loose dust off both filters.

• Figure G - The dust bowls and filters can be

washed in warm soapy water. Allow to dry

before placing back into the vac.

• Figure H To replace the filters, slide the outer plastic filter

over the cloth filter.

• Align the wings of the plastic filter with the slots in the cloth

filter and twist in a counterclockwise direction.

• Place filters back into the bowl pressing firmly to ensure a

secure fit.

• To replace dust bowl, place it back onto the handle until it

“clicks” firmly into position.

IMPORTANT: Maximum dust collection will only be obtained

with a clean filter and an empty dust bowl. If dust begins to fall

back out of the product after it is switched off, this indicates

that the bowl is full and requires emptying.

• Wash the filters regularly using warm, soapy water and

ensure that they are completely dry before using again. The

cleaner the filter is, the better the product will perform.

• It is very important that the filter is correctly in position before

use.