Operating Guide
Removing Dust Bowl and Filters
NOTICE:
obtained with a clean filter and an empty dust
bowl.
NOTICE: Empty dust bowl before it becomes
overfilled. If dust begins to fall back out of the
product after it is switched off, it is too full and
requires emptying.
dust bowl (3) away from the body of the auto vac.
While holding the dust bowl over a bin, pull the filter
out to empty the contents of the bowl.
NOTICE: The auto vac has a pre-filter and an
inner filter. The filters should be separated to allow
better cleaning.
To separate the filters, twist the pre-filter (10) in
a clockwise direction and lift away from the inner
filter (11) as shown in Figure E.
Shake or lightly brush any loose dust off both
filters.
To replace the filters, slide the pre-filter over the
inner filter.
Align the wings of the pre-filter with the slots in
the inner filter and twist in a counterclockwise
direction as shown in Figure F.
ensure a secure fit.
the auto vac until it “clicks” firmly into position.
WARNING: It is very important that the filter is
correctly in position before use.
Cleaning the Dust Bowls and Filters
NOTICE:
Wash the filters regularly. The cleaner the filter is, the better the product will
perform.
The dust bowl and filters can be washed in warm soapy water.
Allow to dry before placing back into the auto vac.
filters back into the bowl pressing firmly to ensure a
secure fit.
position.
Replacing Filters
The filters should be replaced every 6 to 9 months depending on frequency of use, or
when they are worn or damaged. Replacement filters (Catalog Number: VF110) are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
5
F
D
E
10
11